Page 1 of 1

Windws 10 \BCD error

Posted: Thu Apr 21, 2016 12:59 am
by Charger440
If you get a "\BCD" error on Windows 10, it can be resolved by starting up to the console and doing the following:

Step 1, Boot the device and press F11 for system recovery.

Step 2, Under system recovery, select Advanced Options

Step 3 Under advanced options choose command prompt

Step 4, When you are at the command prompt run these options :-

Bootrec /fixMBR
bootrec /fixBoot
bootrec /rebuildBCD

Once done type exit.

Step 5, reboot as normal ......... and hopefully you'll be back in windows 10 with no lost of data.

Information shared from:
http://answers.microsoft.com/en-us/wind ... 0f7?auth=1

Re: Windws 10 \BCD error

Posted: Wed Dec 14, 2016 3:01 pm
by Chester170
I get this error on TTS. I don't know what tool is. Because when I do run it I run all the tools. I had to do an instalation pen instead of F11. Didn't know it works with F11 too, thanks Jim. I know that is a tool before avast antivirus intalation. Do you have any idea wich one? Thanks ;)

Re: Windws 10 \BCD error

Posted: Wed Dec 14, 2016 7:08 pm
by Charger440
Bruno(?)

I really couldn't say for sure but that error is caused by corrupting the boot sector so I would look through the lost that you ran and see if any of the tools should have access to the boot sector and then go from there. I might also use the term "boot record" as with UEFI boot the boot "sector" is not necessarily in the first part of the drive like it used to be

Re: Windws 10 \BCD error

Posted: Wed Dec 14, 2016 7:32 pm
by Chester170
I know it's right before the AVs I just have to figure out wich one. Probably it's one tool that asks me for reboot. Right? Thanks

Re: Windws 10 \BCD error

Posted: Thu Dec 15, 2016 11:39 pm
by Charger440
That could be. If it is rebooting then it wants access to files before Windows loads them so it possible it could be that one.

Re: Windws 10 \BCD error

Posted: Fri Dec 16, 2016 9:43 am
by Chester170
Thanks for the help Jim :)

Re: Windws 10 \BCD error

Posted: Fri Dec 16, 2016 10:03 am
by Charger440
Your welcome even though I didn't give you any solid answers.