Reports

Use this forum to report bugs you find in the software.
Forum rules
We have no special rules for UVK forums. Just try to be polite and clear in your posts.
Please don't post spam in this forum. Spammers will be banned by IP, e-mail and username.
We reserve the right to delete all posts and ban all users we consider not having respected these rules without warning.
Post Reply
Charger440
Posts: 1529
Joined: Sun May 25, 2014 7:44 am
Location: Missouri

Reports

Post by Charger440 »

I already posted about the RepairShopR seemly not working so I did more research and found that after closing the repair section, my professional report does not open in the browser either.

Are these two issues related?

Of note, the report IS created on the desktop BUT subsequent runs of the system repair creates a new repair file instead of appending to the current file. If this is correct action then I'm fine with it, I just thought I would point it out.
Jim

It is not "Can it be done?" but rather, "How can we do it?"
Fred
Site Admin
Posts: 2357
Joined: Sat Jul 30, 2011 12:05 pm
Location: Red coast, France
Contact:

Re: Reports

Post by Fred »

Hey Jim.

Thanks for the bug report. I will check it out ASAP.

I don't know if the report not opening issue is related to RepairShopr, but I will try to figure it out.

Normally UVK appends to the current report until you exit the System repair section, but the same report should be used if the computer is rebooted before the current repair operation ends.
One thing we humans have in common is that we are all different. So, if you think you're weird because you're different from everyone else, then we are all weird.

Fred
Post Reply