My SR setup ends with Uninstall UVK/Defrag Reg/Reboot PC but the three commands don't work together.
As far as duplication, here's what happens:
(I'm simplifying the list to just Cancel Chkdsk/Cancel Memcheck just to put some commands ahead of the very last section)
* Cancel/Cancel/Uninstall/DefragReg/Reboot = reboot but no uninstall. Same if I leave off the last Reboot.
* Cancel/Cancel/Uninstall/Reboot = uninstall but no reboot
The DefragReg command initiates a reboot by itself so having the Reboot command after it may be superfluous but that shouldn't supercede the Uninstall command, right?
This is in the Autoit/official version. If I run the new C++ version from my NAS (since there's not yet a Portable version), it loads at lightning speed(!) and, in the first example, does not reboot (and, since it doesn't 'install', I can't say if that step would be running correctly).
Reboot or uninstall not always working
Forum rules
We have no special rules for UVK forums. Just try to be polite and clear in your posts.
Please don't post spam in this forum. Spammers will be banned by IP, e-mail and username.
We reserve the right to delete all posts and ban all users we consider not having respected these rules without warning.
We have no special rules for UVK forums. Just try to be polite and clear in your posts.
Please don't post spam in this forum. Spammers will be banned by IP, e-mail and username.
We reserve the right to delete all posts and ban all users we consider not having respected these rules without warning.
Re: Reboot or uninstall not always working
Thanks for reporting this again, Xander. I did work on this issue, but it seems I didn't fix it properly. I'll check it out again.
One thing we humans have in common is that we are all different. So, if you think you're weird because you're different from everyone else, then we are all weird.
Fred
Fred